Cruise Control Main Switch Installation

Install the cruise control main switch with the 2 screws.

Torque:

2.4 N*m{24 kgf*cm, 21 in.*lbf}

Connect the connector.

Check that the ignition switch is off.

Check that the battery negative (-) terminal is disconnected.

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

Support the steering pad with one hand.

Connect the 2 airbag connectors to the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

Connect the horn connector to the steering pad.

Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

Using a "TORX" socket (T30), tighten the 2 "TORX" screws.

Torque:

8.8 N*m{90 kgf*cm, 78 in.*lbf}

Engage the claw and install the No. 2 lower steering wheel cover.

Engage the claw and install the No. 3 lower steering wheel cover.