Side Airbag Sensor Installation

Check that the ignition switch is off.

Check that the battery negative (-) cable is disconnected.

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

Install the side airbag sensor with the bolt.

Torque:

9.0 N*m{92 kgf*cm, 80 in.*lbf}

NOTICE:

1. If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
   
2. When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   

Check that there is no looseness in the installation parts of the side airbag sensor.

Connect the connector.

Engage the 2 claws and 2 clips, then install the lower center pillar garnish LH.

Install the rear door opening trim weatherstrip LH as shown in the illustration.

NOTICE:

After installation, check that the corners fit correctly.

Install the front door opening trim weatherstrip LH as shown in the illustration.

NOTICE:

After installation, check that the corners fit correctly.

Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.

Engage the 7 claws and 3 clips, then install the front door scuff plate LH.

Inspect the SRS warning light (CAMRY_ACV40 RM000000XFD07AX.html).