Ultrasonic Sensor (For Rear Side) Removal

Remove the 3 screws and rear quarter panel mudguard sub-assembly LH.

Put protective tape around the rear bumper assembly.

Using a screwdriver, open the 2 rear bumper plates.

HINT:

Tape the screwdriver tip before use.

Remove the 6 screws and 2 clips.

Disengage the 12 claws and disconnect the rear bumper assembly as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

w/ TOYOTA Parking Assist-sensor System:

1. Disconnect the connector.
   

Remove the rear bumper assembly.

Disconnect the sensor connector.

Remove the sensor clip as shown in the illustration.

While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

HINT:

The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.

Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper.

Disconnect the sensor connector.

While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the No. 1 ultrasonic sensor.

HINT:

1. The type of the claw on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
   
2. The illustration is for the LH side. The RH side is the opposite of the LH side.
   

Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper.

HINT:

The illustration is for the LH side. The RH side is the opposite of the LH side.