After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

3. REMOVE CONSOLE PANEL SUB-ASSEMBLY

Механическая Трансмиссия В Сборе - Снятие. МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В БЛОКЕ С ГЛАВНОЙ ПЕРЕДАЧЕЙ G52F. Land Cruiser Prado GRJ150 TRJ150 TRJ155 KDJ150 TRJ155 LJ150

Наклейте защитную клейкую ленту вокруг облицовки панели пола.

Обозначения на рисунке
*1	Защитная клейкая лента

С помощью съемника молдингов расцепите 8 фиксаторов и 2 захвата.

Отсоедините все разъемы и снимите облицовку панели пола.

4. REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

Remove the 4 screws, 2 clips and boot.

Text in Illustration
*1	Clip
*2	Screw

5. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

Cover the shift lever cap with a cloth.

Text in Illustration
*1	Cloth
*a	Down
*b	Counterclockwise

Press down on the shift lever cap and rotate it counterclockwise to remove it.

Pull out the shift lever to remove it.

6. REMOVE TRANSFER CASE LOWER PROTECTOR

Remove the 4 bolts and transfer case lower protector.

7. DRAIN MANUAL TRANSMISSION OIL

Remove the drain plug and gasket and then drain the manual transmission oil.

Remove the filler plug and gasket.

Install a new gasket and the drain plug.

Момент затяжки:
37 N*m{ 377 kgf*cm, 27 ft.*lbf}

8. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Remove the front propeller shaft (See page ).

9. REMOVE PROPELLER SHAFT ASSEMBLY

Remove the propeller shaft (See page ).

10. REMOVE FRONT EXHAUST PIPE ASSEMBLY

Remove the front exhaust pipe (See page ).

11. DISCONNECT WIRE HARNESS

Disconnect the 2 connectors and detach the 4 clamps.

12. REMOVE TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY

Detach the clamp and disconnect the 3 breather hoses from the shift lever retainer and transfer adapter.

Remove the breather hose.

13. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Remove the 2 bolts and disconnect the release cylinder.

14. REMOVE STARTER ASSEMBLY

Remove the starter (See page ).

15. REMOVE FRONT SUSPENSION MEMBER BRACKET LH

Remove the 4 bolts and member bracket.

16. REMOVE FRONT SUSPENSION MEMBER BRACKET RH

Remove the 4 bolts and member bracket.

17. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

Support the rear side of the transmission with a support stand.

Remove the 4 bolts of the rear No. 1 engine mounting insulator.

Remove the 4 bolts, 4 nuts and frame crossmember.

18. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

Remove the 4 bolts and engine mounting insulator.

19. REMOVE STIFFENER PLATE LH

Remove the 4 bolts and stiffener plate.

20. REMOVE STIFFENER PLATE RH

Remove the 4 bolts and stiffener plate.

21. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

Using a transmission jack, support the transmission.

Remove the support stand from the transmission.

Remove the 4 bolts and transmission.

22. REMOVE TRANSFER ASSEMBLY

Для моделей с 1KD-FTV:

Обозначения на рисунке
*A	Для моделей с 1KD-FTV, RA61F
*B	Для моделей с 1KD-FTV, A750F

Выверните 8 болтов и снимите 2 кронштейна.

Кроме моделей с 1KD-FTV:

Выверните 8 болтов и снимите кронштейн.

Отсоедините раздаточную коробку от трансмиссии.

МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В БЛОКЕ С ГЛАВНОЙ ПЕРЕДАЧЕЙ G52F

Land Cruiser Prado GRJ150 TRJ150 TRJ155 KDJ150 TRJ155 LJ150

МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В СБОРЕ