ДАТЧИК АБСОЛЮТНОГО ДАВЛЕНИЯ В КОЛЛЕКТОРЕ - ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

Disconnect the manifold absolute pressure sensor connector.

Measure the voltage according to the value(s) in the table below.

• Standard Voltage:

• Tester Connection	Switch Condition	Specified Condition
  C83-3 (VC) - C83-1 (E)	Ignition switch ON	4.75 to 5.25 V

If the result is not as specified, inspect the wire harness or ECM (See page ).

Connect the manifold absolute pressure sensor connector.

Turn the ignition switch to ON.

Disconnect the vacuum hose from the manifold absolute pressure sensor.

Using SST, measure the voltage according to the value(s) in the table below.

• SST
• 09992-00242

• Standard Voltage:

• Tester Connection	Condition	Specified Condition
  C102-2 (PIM) - C102-9 (E2)	60 kPa (0.61 kgf/cm2, 8.7 psi)	0.4 to 0.6 V
  	87 kPa (0.89 kgf/cm2, 12.6 psi)	1.1 to 1.3 V

• УКАЗАНИЕ:

• The values in the "Condition" column are gauge pressures.

If the result is not as specified, replace the manifold absolute pressure sensor.