ГЕНЕРАТОР - ПОВТОРНАЯ СБОРКА

Using SST and a press, press in the generator rotor.

• SST
• 09285-76010

Place the washer on the generator rotor.

Using a 17 mm socket wrench and press, slowly press on the rectifier end frame.

Install the cord clip and 4 nuts.

• Момент затяжки:
• 5.9 N*m{ 60 kgf*cm, 52 in.*lbf}

Install the 4 rubber insulators to the lead wires.

Text in Illustration

Inside

• ПРИМЕЧАНИЕ:

• Be careful to install the rubber insulators in the correct direction.

While pushing down on the rectifier holder, install it with the 4 screws.

• Момент затяжки:
• 2.9 N*m{ 30 kgf*cm, 26 in.*lbf}

Text in Illustration

Push

Install the regulator with the 3 screws.

• Момент затяжки:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Install the plate seal.

Install the brush holder with the 2 screws.

• Момент затяжки:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Text in Illustration

Upper

Install the brush holder cover.

Install the rear end cover and rectifier plate with the bolt and 3 nuts.

• Момент затяжки:
• for nut:
• 4.4 N*m{ 45 kgf*cm, 39 in.*lbf}
• for bolt:
• 3.9 N*m{ 40 kgf*cm, 35 in.*lbf}

Install the terminal insulator with the nut.

• Момент затяжки:
• 4.1 N*m{ 42 kgf*cm, 36 in.*lbf}

Align the matchmarks and install the vacuum pump with the 4 bolts.

• Момент затяжки:
• 7.8 N*m{ 80 kgf*cm, 69 in.*lbf}