Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - THEFT DETERRENT / KEYLESS ENTRY
THEFT DETERRENT SYSTEM (w/o Entry and Start System) - OPERATION CHECK
- HINT:
- If the battery is reconnected during the armed state, the system may enter the alarm sounding state and the alarm may sound. If so, perform a wireless unlock operation to stop the alarm.
OUTLINE OF THEFT DETERRENT SYSTEM |
When the theft deterrent system detects that the vehicle is being tampered with, the horns sound and the hazard warning lights flash continuously.
The system has a mode called active arming mode (refer to "Active Arming Mode").
Active arming mode has 4 states: disarmed state, arming preparation state, armed state and alarm sounding state.
Disarmed state:
Arming preparation state:
Armed state:
Alarm sounding state:
Alarm Method | Hazard Warning Light | Blinking (cycle of flasher relay) |
Vehicle Horn | Sounding (cycle of 0.4 seconds) | |
Security Horn | Sounding (cycle of 0.4 seconds) | |
Security Indicator | Illuminated | |
Alarm Time | 30 +/-2.5 seconds |
- HINT:
- If, during the alarm sounding state, one of the doors is unlocked without using a proper key, a forced door lock signal will be output (refer to "Forced Door Lock Control").
ACTIVE ARMING MODE |
- HINT:
- Active arming mode starts alarm control immediately after the doors are locked.
System State | State Switching Condition | Transfer to |
1. Disarmed state | Perform one of following, and system will go on to "Arming preparation state": With all doors and engine hood closed, lock all doors by wireless operation. With all doors and engine hood closed, lock all doors using mechanical key. With all doors locked and the engine hood closed, any door or the engine hood is opened and then closed. | 2. Arming preparation state |
2. Arming preparation state | Perform one of following, and system will go on to "Disarmed state": Unlock all doors by wireless operation. Unlock all doors using mechanical key. Unlock door. Open the engine hood or any doors. Insert the key* into the ignition key cylinder, and then turn the ignition switch to ACC or ON. Reconnect battery. | 1. Disarmed state |
Perform one of following, and system will go on to "Armed state": Allow 30 (+/-1.5) seconds to elapse. | 3. Armed state | |
3. Armed State | Perform one of following, and system will go on to "Disarmed state": Unlock all doors by wireless operation. Unlock all doors using mechanical key. With the ignition switch turned to ON and the engine having been turned on for 2 seconds, or more. Insert the key* into the ignition key cylinder, and then turn the ignition switch to ACC or ON. | 1. Disarmed state |
Perform one of following, and system will go on to "Alarm sounding state": Open engine hood. Open door. Unlock door without using wireless operation. Unlock door without using mechanical key. Disconnect and reconnect battery negative (-) cable. Force engine ignition system to turn on without proper engine start method. | 4. Alarm sounding state | |
4. Alarm sounding state | Perform one of following, and system will go on to "Disarmed state": Unlock all doors using wireless operation. Unlock all doors using mechanical key. With the ignition switch turned to ON and the engine having been turned on for 2 seconds, or more. Insert the key* into the ignition key cylinder, and then turn the ignition switch to ACC or ON. | 1. Disarmed state |
Perform one of following, and system will go on to "Armed state": Allow 30 (+/-2.5) seconds to elapse. | 3. Armed state (alarm stops sounding) |
- HINT:
- *: Unlock warning switch signal is on.
FORCED DOOR LOCK CONTROL |
Forced door lock control also helps to prevent the vehicle from being tampered with. When a door is unlocked and the alarm starts, the door is forced to lock by a forced door lock signal.
Conditions that force the doors to lock:
SECURITY INDICATOR OUTPUT |
The security indicator turns on and off based on output signals from the main body ECU. However, in some cases, the actual status of the security indicator is different from the output signals of the transponder key ECU assembly.
State of Theft Deterrent System | Security Indicator | |
Output Signals from ECU | Actual Lighting Condition | |
Disarmed state | Off | Off (Immobiliser system not set) Blinking (Immobiliser system set) |
Arming preparation state | On | On |
Armed state | Off | Blinking |
Alarm sounding state | On | On |
Time | Security Indicator |
0.125 seconds | On |
1.875 seconds | Off |
- HINT:
- When the immobiliser system is set, the security indicator blinks during the disarmed state and the armed state due to the output signals from the immobiliser system.