Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - THEFT DETERRENT / KEYLESS ENTRY
THEFT DETERRENT SYSTEM (w/ Entry and Start System) - DATA LIST / ACTIVE TEST
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on intelligent tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Intrusion sensor OFF | Intrusion sensor cancel switch / ON or OFF | ON: Intrusion sensor active (switch off) OFF: Intrusion sensor not active (switch on) | - |
| Intrusion sensor detection | Intrusion sensor setting / ON or OFF | ON: Moving object detected by sensor during arming preparation state to armed state OFF: No moving object detected by sensor | - |
| Tilt sensor detection | Tilt sensor setting / ON or OFF | ON: Tilt sensor set OFF: Tilt sensor not set | - |
| Hood Courtesy Switch | Engine hood courtesy switch / ON or OFF | ON: Engine hood open OFF: Engine hood closed | - |
| Warn By Horn | Security horn / ON or OFF | ON: Security horn sounding OFF: Security horn not sounding | - |
| Glass break sensor detection | Glass breakage sensor detection / ON or OFF | ON: Glass breakage sensor operates OFF: Glass breakage sensor does not operate | - |
| Pattern Glass Connection | Pattern Glass Connection / OK or NG | OK: Pattern glass connection NG: No pattern glass connection | - |
| Intrusion sensor 1 communication | Intrusion sensor setting / OK or STOP | OK: Intrusion sensor set STOP: Intrusion sensor not set | - |
| Tilt sensor communication | Tilt sensor setting / OK or STOP | OK: Tilt sensor set STOP: Tilt sensor not set | - |
| Tilt sensor OFF Switch | Tilt sensor OFF switch / ON or OFF | ON: Tilt sensor active (switch off) OFF: Tilt sensor not active (switch on) | - |
| # Codes | Number of diagnostic trouble codes | - | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door opened OFF: Driver side door closed | - |
| D Door Lock Pos SW | Driver side door lock position switch signal / ON or OFF | ON: Driver side door unlocked OFF: Driver side door locked | - |
| Door Key SW-Lock | Door key linked lock switch signal / ON or OFF | ON: Driver side door key cylinder turned to lock position OFF: Driver side door key cylinder not turned | - |
| D-Door Key SW-UL | Door key linked unlock switch signal / ON or OFF | ON: Driver side door key cylinder turned to unlock position OFF: Driver side door key cylinder not turned | - |
| P-Door Courtesy SW | Front passenger side door courtesy light switch signal / ON or OFF | ON: Front passenger side door opened OFF: Front passenger side door closed | - |
| P-Door Lock Pos SW | Front passenger side door lock position switch signal / ON or OFF | ON: Front passenger side door unlocked OFF: Front passenger side door locked | - |
| Door Lock SW-Lock | Door manual lock switch signal / ON or OFF | ON: Front passenger side door control switch on (LOCK) OFF: Front passenger side door control switch off | - |
| Door Unlock SW-Unlock | Door manual unlock switch signal / ON or OFF | ON: Front passenger side door control switch on (UNLOCK) OFF: Front passenger side door control switch off | - |
| RL Door Courtesy SW | Rear LH side door courtesy light switch signal / ON or OFF | ON: Rear LH side door opened OFF: Rear LH side door closed | - |
| RL-Door Lock Pos SW | Rear LH side door lock position switch signal / ON or OFF | ON: Rear LH side door unlocked OFF: Rear LH side door locked | - |
| RR Door Courtesy SW | Rear RH side door courtesy light switch signal / ON or OFF | ON: Rear RH side door opened OFF: Rear RH side door closed | - |
| RR-Door Lock Pos SW | Rear RH side door lock position switch signal / ON or OFF | ON: Rear RH side door unlocked OFF: Rear RH side door locked | - |
| Back Door Courtesy SW | Back door courtesy light switch signal / ON or OFF | ON: Back door open OFF: Back door closed | - |
| Back Door Open SW | ON / OFF | ON: Back door opener switch on OFF: Back door opener switch off | - |
| Back Door Open | Permit / Prohibit | PERMIT: Back door open available PROHIBIT: Back door open unavailable | - |
| IG SW | ON / OFF | ON: Engine switch is on (IG) OFF: Engine switch is off | - |
| ACC SW | ON / OFF | ON: Engine switch on (ACC) OFF: Engine switch off | - |
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform the Active Test allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
According to the display on intelligent tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator | ON / OFF | - |
| Security Horn*1 | Security horn | ON / OFF | - |
| Security Horn2*2 | Theft warning siren (self power siren) | ON / OFF | - |
| Power For Tilt Sensor*3 | Tilt sensor power supply | ON / OFF | - |
| Power For Intrusion Sensor*3 | Intrusion sensor power supply | ON / OFF | - |
- HINT:
- *1: w/ Security Horn
- *2: w/ Theft Warning Siren (Self Power Siren)
- *3: w/ Intrusion Sensor