Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SEAT
SEAT MEMORY SWITCH (w/ Seat Position Memory System) - REMOVAL
- HINT:
Use the same procedures for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
| 1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH |
Detach the clip and claw, and remove the front door lower frame bracket garnish LH.
| 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH |
Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.
- HINT:
- Tape the screwdriver tip before use.
| *1 | Protective Tape |
| 3. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH |
Using a moulding remover, detach the 5 claws.
Disconnect the connector and remove the armrest base panel.
| 4. REMOVE DOOR ASSIST GRIP COVER LH |
Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.
| 5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the 3 screws.
Remove the 13 clips.
Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.
- HINT:
- Make sure that the pin labeled A in the illustration is detached from the door panel.
Disconnect the connector.
Disconnect the 2 cables from the front door inside handle sub-assembly LH.
| 6. REMOVE SEAT MEMORY SWITCH |
Disconnect the connector.
Remove the screw and seat memory switch.