INSPECT SEAT HEATER SWITCH

Measure the resistance according to the value(s) in the table below.

• Standard Resistance:

• Tester Connection	Switch Condition	Specified Condition
  1 (RV) - 6 (SW) 3 (RV) - 4 (SW)	Switch off	2.7 to 4.1 kΩ
  	Switch on (Min)
  	Switch on (Max)	0.28 to 0.42 kΩ

• HINT:

• As the dial is being turned, the resistance changes gradually.

If the result is not as specified, replace the seat heater switch.

Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

• OK:

• Measurement Condition	Specified Condition
  Battery positive (+) → 8 (ILL+) Battery negative (-) → 5 (ILL-)	Illuminates

If the result is not as specified, replace the seat heater switch.