CHECK MAP LIGHT ASSEMBLY

Remove the map light with the connector connected.

Measure the voltage according to the value(s) in the table below.

• Standard Voltage:

• Tester Connection	Switch Condition	Specified Condition
  R7-6 (RILL) - R7-17 (GND9)	Rear dome light off	11 to 14 V
  	Rear dome light on	Below 1 V
  R7-10 (ILL-) - R7-17 (GND9)	Headlight dimmer switch off	11 to 14 V
  	Headlight dimmer switch on	Below 1 V
  R7-13 (ILL+) - R7-17 (GND9)	Engine switch on (ACC)	11 to 14 V
  R7-15 (+B) - R7-17 (GND9)	Always	11 to 14 V
  R7-16 (DOME) - R7-17 (GND9)	Always	11 to 14 V

Measure the resistance according to the value(s) in the table below.

• Standard Resistance:

• Tester Connection	Condition	Specified Condition
  R7-1 (GND6) - Body ground	Always	Below 1 Ω
  R7-17 (GND9) - Body ground	Always	Below 1 Ω

If the result is not as specified, replace the map light assembly.