Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SEAT
LUMBAR SWITCH (for Power Seat) - REMOVAL
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat assembly ().
| 2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a screwdriver, detach the 2 claws and remove the slide and vertical power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE RECLINING POWER SEAT SWITCH KNOB |
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
| *1 | Protective Tape |
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
Remove the 2 screws.
Disconnect the 2 rubber bands.
Remove the 3 screws.
Detach the 2 claws and remove the front seat cushion shield LH together with the front inner No. 1 seat cushion shield LH.
for Driver Side:
Disconnect the connector.
| 5. REMOVE LUMBAR SWITCH (for Driver Side) |
Remove the 2 screws and switch.