Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SEAT
LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) - REMOVAL
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
()
| 2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a screwdriver, detach the 2 claws and remove the slide and vertical power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE RECLINING POWER SEAT SWITCH KNOB |
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
| *1 | Protective Tape |
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
Remove the 2 screws.
Disconnect the 2 rubber bands.
Remove the 3 screws.
Detach the 2 claws and remove the front seat cushion shield LH together with the front inner No. 1 seat cushion shield LH.
for Driver Side:
Disconnect the connector.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
Disconnect the connectors and detach the clamps.
Remove the nut and front seat inner belt assembly.
Remove the front seat belt anchor plate.
| 6. REMOVE FRONT INNER SEAT CUSHION SHIELD LH |
Remove the screw.
Detach the 2 claws and clip, and then remove the front inner seat cushion shield LH.
| 7. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH |
Remove the 2 screws.
Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 hooks and remove it.
| 8. REMOVE SEAT CLIMATE CONTROL CONTROLLER LH (w/ Climate Control Seat System) |
Detach the 2 claws and disconnect the seat climate control blower LH.
Detach the 4 hooks and remove the seat climate control controller LH.
| 9. REMOVE FRONT SEAT HEADREST SUPPORT |
Detach the 4 claws and remove the 2 front seat headrest supports.
| 10. REMOVE SEATBACK COVER WITH PAD |
w/o Climate Control Seat System:
Disconnect the connector and detach the 2 wire harness clamps.
w/ Climate Control Seat System:
Disconnect the 2 connectors and detach the 4 wire harness clamps.
Remove the hog rings.
| *1 | Hog Ring |
Remove the nut and detach the seatback cover bracket.
| *1 | Seatback Cover Bracket |
Detach the hooks and remove the seatback cover with pad.
| 11. REMOVE FRONT SEATBACK PROTECTOR |
Remove the front seatback protector.
Remove any remaining double-sided tape.
| *1 | Double-sided Tape |
| 12. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH |
Remove the cable clamp and disconnect the active headrest cable from the seatback spring.
| *1 | Cable Clamp |
| *2 | Hook |
Remove the 4 springs.
Detach the 4 hooks and remove the seatback spring.
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster assembly LH.