LIGHT CONTROL RHEOSTAT - REMOVAL

1. DISABLE AUTO TILT AWAY FUNCTION

Disable the Autoaway/Return function by changing the customize parameter ().

Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

Turn the engine switch off.

2. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Place protective tape as shown in the illustration.

Text in Illustration
*1	Protective Tape

Using a moulding remover, detach the 3 claws and remove the No. 1 instrument cluster finish panel garnish.

3. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Place protective tape as shown in the illustration.

Using a moulding remover, detach the 7 claws and remove the panel cushion.

4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Remove the clip.

Remove the screw.

Detach the 8 claws.

Remove the panel pad and disconnect the connectors and 2 clamps.

5. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Place protective tape as shown in the illustration.

Using a moulding remover, detach the 2 claws and remove the No. 2 instrument cluster finish panel garnish.

Light Control Rheostat - Removal. METER / GAUGE / DISPLAY. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Text in Illustration
*A	w/ Entry and Start System	*B	w/o Entry and Start System
*1	Protective Tape	-	-

6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Detach the 9 claws.

Disconnect the connector and remove the instrument cluster finish panel.

7. REMOVE LIGHT CONTROL RHEOSTAT

Detach the 2 claws and remove the rheostat.