SELECT COMPASS DISPLAY MODE

SET ZONE

PERFORM CALIBRATION

WHEN COMPASS IS MAGNETIZED

Deviation Calibration Procedure

Circling Calibration Procedure

The compass switch allows you to select the Display or Non-display mode of the compass.

Deviation between the "magnetic north" and "actual north" differs depending on the location. Therefore, adjustment of the magnetism is required. Because the magnetic condition differs depending on the area where the vehicle is used, it is necessary for each user to set the zone (refer to Compass Zone Map). The zone setting can be changed using the compass switch of the inner mirror.

Because each vehicle has its own magnetic field, calibration should be performed for each individual vehicle. This compass function is used when storing the record of the vehicle's magnetic field.

The compass could be magnetized during shipping by vessels or freight cars. Therefore, ensure that calibration is performed properly before delivery. If driving the vehicle in a circle several times does not complete the calibration procedure, there may be a compass magnetization problem.

Turn the ignition switch to the "IG-ON" position and push and hold the "AUTO" switch for 6 seconds until the zone number appears on the display.

• HINT:

• Pushing the "AUTO" switch for 3 seconds turns on or off the compass display.

Push the "AUTO" switch to select the number of the zone where the vehicle is located.

See the map for zone reference.

Start the engine and push and hold the "AUTO" switch for 9 seconds until "C" appears on the display.

Drive the vehicle slowly at 8 km/h (5 mph) or lower in a circle.

If there is not enough space to drive in a circle, turn the car around in the following manner, doing two three-point turns in succession.

After driving in 1 to 3 circles in the above method, calibration is completed with the direction is shown on the display.

• HINT: