If the bellcrank lever is not pulled and held when installing the outside handle, the bellcrank lever will interfere with the outside handle and the release plate may be damaged.

Insert the rear end of the rear door outside handle assembly into the rear door outside handle frame. Next, slide the rear door outside handle assembly toward the front of the vehicle to install it.

Using a T30 ''TORX'' socket, tighten the screw.

Connect the connector.

2. INSTALL REAR DOOR OUTSIDE HANDLE COVER LH

Attach the claw to install the rear door outside handle cover LH.

Using a T30 ''TORX'' socket, install the rear door outside handle cover LH with the screw.

3. INSTALL REAR DOOR LOCK ASSEMBLY LH

Apply MP grease to the sliding parts of the rear door lock assembly.

Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

Using a T30 ''TORX'' wrench, the 3 screws.

Torque:
5.0 N*m{ 51 kgf*cm, 44 in.*lbf}

4. INSTALL REAR DOOR SERVICE HOLE COVER LH

Apply butyl tape to the door.

Pass the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH through a new rear door service hole cover LH.

NOTICE:

When installing the rear door service hole cover LH, pull the links and connectors through the rear door service hole cover LH.

There should be no wrinkles or folds after attaching the rear door service hole cover LH.

After attaching the rear door service hole cover LH, check the sealing quality.

Connect the 2 connectors.

Attach the 6 clamps.

Install the bolt as shown in the illustration.

Torque:
8.4 N*m{ 86 kgf*cm, 74 in.*lbf}

5. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Connect the connector.

Attach the claw of the courtesy light to the rear door trim.

6. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Connect the connector.

Connect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH to the rear door inside handle sub-assembly LH.

Attach the 4 claws and 9 clips to install the rear door trim board sub-assembly LH.

Install the 3 screws.

7. INSTALL ASSIST GRIP COVER LH

Attach the 9 claws to install the assist grip cover LH to the rear door trim board sub-assembly LH.

8. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Attach the 4 claws to install the rear door inside handle bezel LH.

9. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Connect the connector.

Attach the 7 claws to install the armrest base panel.

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().

THEFT DETERRENT / KEYLESS ENTRY

Land Cruiser URJ200 URJ202 GRJ200 VDJ200

ENTRY LOCK AND UNLOCK SWITCH for Rear