ELECTRICAL KEY OSCILLATOR (for Front Floor) - REMOVAL

Use the same procedures for LHD and RHD vehicles.

The procedures listed below are for LHD vehicles.

1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Place protective tape as shown in the illustration.

Using a moulding remover, detach the 7 claws and remove the panel cushion.

2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Remove the clip.

Remove the screw.

Detach the 8 claws.

Remove the panel pad and disconnect the connectors and 2 clamps.

3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

Place protective tape as shown in the illustration.

Using a moulding remover, detach the 7 claws and remove the panel cushion.

4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Remove the clip.

Remove the screw.

Detach the 7 claws and remove the panel.

5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Twist the shift lever knob in the direction indicated by the arrow and remove it.

Electrical Key Oscillator (For Front Floor) - Removal. THEFT DETERRENT / KEYLESS ENTRY. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

6. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Detach the 7 claws.

Disconnect the connectors and remove the panel.

7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Detach the 9 claws and remove the panel.

8. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

Detach the 4 claws and remove the box.

9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Detach the 14 claws.

Disconnect the connectors and remove the console panel.

10. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR

Disconnect the connector.

Detach the 2 claws and remove the electrical key oscillator.