Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - HEATING / AIR CONDITIONING
DUCT TEMPERATURE SENSOR (w/ Heater) - REMOVAL
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH |
for 60/40 Split Seat Type 40 Side:
()
for 60/40 Split Seat Type 60 Side:
()
| 4. REMOVE REAR NO. 1 SEAT ASSEMBLY RH |
for 60/40 Split Seat Type 40 Side:
()
for 60/40 Split Seat Type 60 Side:
()
| 5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH |
for Face to Face Seat Type:
()
except Face to Face Seat Type:
()
| 6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH |
for Face to Face Seat Type:
()
except Face to Face Seat Type:
()
| 7. REMOVE REAR DOOR SCUFF PLATE LH |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 8. REMOVE REAR DOOR SCUFF PLATE RH |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 10. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Remove the tonneau cover.
| 11. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat) |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 13. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat) |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH |
w/ Sliding Roof:
()
w/o Sliding Roof:
()
| 15. REMOVE REAR NO. 1 SEAT PROTECTOR |
Detach the 10 claws and remove the 2 seat protectors.
| 16. REMOVE REAR NO. 2 SEAT PROTECTOR |
Detach the 10 claws and remove the 2 seat protectors.
| 17. REMOVE FRONT FLOOR CARPET ASSEMBLY |
Fold back the floor carpet.
- HINT:
- Fold back the carpet until it is possible to remove the rear No. 6 air duct.
| 18. REMOVE REAR NO. 6 AIR DUCT |
Disconnect the 2 connectors.
Remove the 5 screws and duct.
| 19. REMOVE DUCT TEMPERATURE SENSOR |
Detach the 4 claws and remove the 2 sensors.
