DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK WHETHER DTC OUTPUT RECURS
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)
INSPECT MAIN BODY ECU
DTC B2276 ACCR Signal Circuit Malfunction
DESCRIPTION
This DTC is stored when a malfunction is detected in the ACCR signal output by the main body ECU.
DTC Code | Detection Condition | Trouble Area |
B2276 | The ACCR output circuit inside the main body ECU or other related circuit is malfunctioning. | Main body ECU
ECM
Harness or connector
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK WHETHER DTC OUTPUT RECURS |
Check whether DTC B2276 is output 50 seconds or more after the engine switch is turned on (IG).
ResultResult | Proceed to |
DTC B2276 output | A |
No DTC output | B |
| USE SIMULATION METHOD TO CHECK (SYSTEM IS OK) ()
|
|
|
2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the E2 main body ECU connector.
Disconnect the A38 (for LHD) or A52 (for RHD) ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance (for 1UR-FE, 3UR-FE, 1GR-FE):
Tester Connection | Condition | Specified Condition |
E2-3 (ACCR) - A38-41 (ACCR)*1 E2-3 (ACCR) - A52-41 (ACCR)*2 | Always | Below 1 Ω |
E2-3 (ACCR) or A38-41 (ACCR) - Body ground*1 E2-3 (ACCR) or A52-41 (ACCR) - Body ground*2 | Always | 10 kΩ or higher |
- Standard Resistance (for 1VD-FTV w/o DPF):
Tester Connection | Condition | Specified Condition |
E2-3 (ACCR) - A38-13 (ACCR)*1 E2-3 (ACCR) - A52-13 (ACCR)*2 | Always | Below 1 Ω |
E2-3 (ACCR) or A38-13 (ACCR) - Body ground*1 E2-3 (ACCR) or A52-13 (ACCR) - Body ground*2 | Always | 10 kΩ or higher |
- Standard Resistance (for 1VD-FTV w/ DPF):
Tester Connection | Condition | Specified Condition |
E2-3 (ACCR) - A38-22 (ACCR)*1 E2-3 (ACCR) - A52-22 (ACCR)*2 | Always | Below 1 Ω |
E2-3 (ACCR) or A38-22 (ACCR) - Body ground*1 E2-3 (ACCR) or A52-22 (ACCR) - Body ground*2 | Always | 10 kΩ or higher |
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection | Condition | Specified Condition |
E2-3 (ACCR) - Body ground | Engine switch pressed and engine cranking | 11 to 14 V |
ResultResult | Proceed to |
Outside specified range | A |
Within specified range (for 1GR-FE) | B |
Within specified range (for 1UR-FE) | C |
Within specified range (for 3UR-FE) | D |
Within specified range (for 1VD-FTV) | E |