Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DOOR LOCK
BACK DOOR LOCK - INSPECTION
| 1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door) |
| *1 | Full-latch | *2 | Open-latch |
| *a | Component without harness connected (Back Door Lock assembly) | - | - |
Set the back door lock to the full-latch position.
Apply battery voltage to the door motor connector and check the operation of the door lock motor.
- OK:
Measurement Condition Specified Condition Battery positive (+) → 2 (ACT+)
Battery negative (-) → 1 (ACT-)Moves to open-latch position
If the result is not as specified, replace the back door lock assembly.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (ACT-) - 3 (+) Open-latch Below 1 Ω 1 (ACT-) - 3 (+) Full-latch 10 kΩ or higher
If the result is not as specified, replace the back door lock assembly.
| 2. INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door) |
Inspect the closer motor operation.
Set the back door lock assembly to the full-latch position.
Apply battery voltage and check the operation of the door lock motor.
- OK:
Measurement Condition Specified Condition Battery positive (+) → 1 (M+)
Battery negative (-) → 2 (M-)Moves to open-latch position
If the result is not as specified, replace the back door lock assembly.
Set the back door lock assembly to the half-latch position.
Apply battery voltage and check the operation of the door lock motor.
- OK:
Measurement Condition Specified Condition Battery positive (+) → 2 (M-)
Battery negative (-) → 1 (M+)Moves to over-latch position
If the result is not as specified, replace the back door lock assembly.
| *1 | Release |
| *2 | Close |
| *3 | Drive Gear |
| *4 | Over-latch |
| *5 | Full-latch |
| *6 | Half-latch |
| *7 | Open-latch |
| *a | Component without harness connected (Back Door Lock Assembly) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Half-latch Switch Tester Connection Condition Specified Condition 5 (CLS) - 4 (E) Over-latch Below 1 Ω Full-latch 10 kΩ or higher Half-latch 10 kΩ or higher Open-latch Below 1 Ω
If the result is not as specified, replace the back door lock assembly.
- Closer Position Switch:
Tester Connection Condition Specified Condition 6 (OPN) - 4 (E) Selector gear is in center position Below 1 Ω Selector gear is not in center position 10 kΩ or higher
If the result is not as specified, replace the back door lock assembly.
- Back Door Courtesy Switch:
Tester Connection Condition Specified Condition 3 (CTY) - 4 (E) Half-latch
Open-latchBelow 1 Ω Over-latch
Full-latch10 kΩ or higher
If the result is not as specified, replace the back door lock assembly.
| *1 | Release |
| *2 | Close |
| *3 | Closer Position Switch |
| *4 | Selector Gear |
| *5 | Drive Gear |
| *6 | Over-latch |
| *7 | Full-latch |
| *8 | Half-latch |
| *9 | Open-latch |
| *a | Component without harness connected (Back Door Lock Assembly) |