Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DOOR LOCK
BACK DOOR LOCK (for Double Swing Out Type) - REMOVAL
1. REMOVE ASSIST GRIP LH |
Using a screwdriver, detach the 2 claws and open the 2 covers.
- HINT:
- Tape the screwdriver tip before use.
*1 | Protective Tape |
Remove the 2 bolts and assist grip.
2. REMOVE DOOR INSIDE HANDLE BEZEL LH |
Detach the claw and open the cover.
Remove the screw.
Using a screwdriver, detach the 2 claws.
- HINT:
- Tape the screwdriver tip before use.
*1 | Protective Tape |
Detach the guide and remove the door inside handle bezel in the direction indicated by the arrow in the illustration.
3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY LH |
Detach the 10 clips and remove the back door trim panel.
4. REMOVE REAR ASSIST GRIP REINFORCEMENT LH |
Remove the 3 bolts and rear assist grip reinforcement.
5. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY LH |
Remove the screw.
Detach the guide and remove the back door inside handle in the direction indicated by the arrow in the illustration.
Disconnect the 2 links from the back door inside handle.
6. REMOVE BACK DOOR SERVICE HOLE COVER LH |
Disconnect the 2 connectors and detach the 3 clamps.
Pull out the 2 links and wire harness from the back door service hole cover, and then remove the back door service hole cover.
- HINT:
- Remove any remaining butyl tape from the back door panel.
7. REMOVE BACK DOOR LOCK ASSEMBLY |
Rotate the snap as shown in the illustration and disconnect the back door lock locking link from the back door lock control assembly.
Disconnect the back door lock cable assembly from the back door remote control assembly.
*1 | Snap |
*2 | Back Door Lock Locking Link |
*3 | Back Door Lock Control Assembly |
*4 | Back Door Remote Control Assembly |
*5 | Back Door Lock Cable Assembly |
Disconnect the 2 connectors.
Using a T30 "TORX" socket wrench, remove the 4 screws and back door lock assembly.