Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DOOR LOCK
BACK DOOR LOCK (for Double Swing Out Type) - INSPECTION
| 1. INSPECT BACK DOOR LOCK ASSEMBLY |
Check the operation of the door lock motor.
Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.
- OK:
Measurement Condition Specified Condition Battery positive (+) → Terminal 2 (ACT+)
Battery negative (-) → Terminal 3 (ACT-)Lock Battery positive (+) → Terminal 3 (ACT-)
Battery negative (-) → Terminal 2 (ACT+)Unlock
If the result is not as specified, replace the back door lock assembly.
| *a | Lock |
| *b | Unlock |
| *c | Component without harness connected (Back Door Lock Assembly) |
Check the detection switch.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Switch Condition Specified Condition 1 (S) - 4 (E) Lock 10 kΩ or higher Unlock Below 1 Ω
If the result is not as specified, replace the back door lock assembly.
Check the operation of the door courtesy switch.
| *a | Component without harness connected (Back Door Lock Assembly) | *b | Full Latch |
| *c | Half Latch | *d | Open |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 1 (E) - 2 (+) Open Below 1 Ω Half Latch Below 1 Ω Full Latch 10 kΩ or higher
If the result is not as specified, replace the back door lock assembly.