Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SUPPLEMENTAL RESTRAINT SYSTEMS
AIRBAG SYSTEM - DATA LIST / ACTIVE TEST
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Data List.
According to the display on tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Driver Seat Position | Driver Seat Position/ FORWARD: Seat position is forward BKWARD: Seat position is backward FAIL: Failure detected | FORWARD/BKWARD | - |
| Passenger Detection | Passenger Detection/ NG: Data is not determined OFF: Vacant NONE: No passenger DETECT: A passenger is seated FAIL: Failure detected | NONE/DETECT | - |
| Right Side Buckle SW | Right Side Buckle SW/ UNSET: The seat belt is not fastened SET: The seat belt is fastened NG: Data is not determined | UNSET/SET | - |
| Left Side Buckle SW | Left Side Buckle SW/ UNSET: The seat belt is not fastened SET: The seat belt is fastened NG: Data is not determined | UNSET/SET | - |
| Display Type Information | Display Type Information/ LR: The display is indicated by LH/RH DP: The display is indicated by Driver/Passenger | LR | - |
| Number of Past DTC | Number of Past DTCs/ Min.: 0, Max.: 255 | 0 | - |