After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().

3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

Detach the 8 claws and remove the opening cover.

4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Place protective tape as shown in the illustration.

Text in Illustration
*1	Protective Tape

Using a moulding remover, detach the 6 claws.

Disconnect the connector and remove the No. 3 instrument panel register.

5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Place protective tape as shown in the illustration.

Text in Illustration
*1	Protective Tape

Using a moulding remover, detach the 6 claws.

Disconnect the connector and remove the No. 4 instrument panel register.

6. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

w/o Stereo Component Amplifier:

()

w/o Multi-dsplay:

()

7. REMOVE NO. 1 CENTER INSTRUMENT CLUSTER FINISH PANEL

Detach the 10 claws.

Disconnect the connector and remove the No. 1 center instrument cluster finish panel.

8. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Put protective tape around the No. 2 instrument panel finish panel cushion.

Text in Illustration
*1	Protective Tape

Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.

9. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Remove the clip and screw.

Detach the 8 claws.

Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.

10. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Put protective tape around the No. 1 instrument panel finish panel cushion.

Text in Illustration
*1	Protective Tape

Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.

11. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Remove the clip and screw.

Detach the 7 claws and remove the lower instrument panel pad sub-assembly.

12. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Detach the 7 claws.

Disconnect the connectors and remove the lower center instrument cluster finish panel sub-assembly.

13. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

Pull the radio receiver to detach the 5 claws on the backside of the radio receiver.

Disconnect the connectors and remove the radio receiver.