Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - DOOR / HATCH
TAIL GATE CLOSER SYSTEM - DATA LIST / ACTIVE TEST
DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body No. 4 / Data List.
According to the display on the tester, read the Data List.
Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
Handle Switch of tail gate panel | Back door remote control signal / ON or OFF | ON: Back door remote control pulled OFF: Back door remote control free | - |
Half Latch Switch RH | Half-latch switch RH signal / ON or OFF | ON: Lower tail gate open OFF: Lower tail gate closed | - |
Half Latch Switch LH | Half-latch switch LH signal / ON or OFF | ON: Lower tail gate open OFF: Lower tail gate closed | - |
Courtesy Switch RH | Lower tail gate courtesy switch RH signal / ON or OFF | ON: Lower tail gate open OFF: Lower tail gate closed | - |
Courtesy Switch LH | Lower tail gate courtesy switch LH signal / ON or OFF | ON: Lower tail gate open OFF: Lower tail gate closed | - |
Position Switch RH | Close position switch RH signal / ON or OFF | ON: Lower tail gate closed OFF: Lower tail gate open | - |
Position Switch LH | Close position switch LH signal / ON or OFF | ON: Lower tail gate closed OFF: Lower tail gate open | - |
Luggage Pawl Switch | Pawl switch signal / ON or OFF | ON: Lower tail gate lock motor operating OFF: Lower tail gate open or closed | - |
Fail Count RH | Number of malfunctions detected in lower tail gate lock RH / 0 to 5 | Number of detected malfunctions displayed | - |
Fail Count LH | Number of malfunctions detected in lower tail gate lock LH / 0 to 5 | Number of detected malfunctions displayed | - |
# Codes | Number of stored trouble codes / min.: 0, max.: 255 | Number of DTCs displayed | - |
ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform the Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body No. 4 / Active Test.
According to the display on the tester, perform the Active Test.
Tester Display | Test Part | Control Range | Diagnostic Note |
Tail Gate Panel Open | Lower tail gate lock | ON / OFF | The back door must be open. |