Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SLIDING ROOF / CONVERTIBLE
SLIDING ROOF HOUSING - DISASSEMBLY
| 1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
Detach the bracket claw and remove the bracket.
Remove the 2 bolts, room light bracket and drive gear.
| 2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY |
Remove the 2 screws.
Detach the 4 claws and remove the sliding roof piece LH and RH.
Slide and remove the trim.
| 3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH |
Remove the stopper.
| 4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH |
- HINT:
- Use the same procedures described for the LH side.
| 5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
- NOTICE:
- Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.
Remove the 2 screws and 2 stoppers.
Using a screwdriver, detach the 2 claws slide the rear roof drip channel rearward to remove it.
- HINT:
- Tape the screwdriver tip before use.
Hold down the window deflector.
Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.
Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.
- HINT:
- Tape the screwdriver tip before use.