POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) - INITIALIZATION

INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR [ALL DOORS])

CAUTION:

When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up/down, jam protection and key-off do not operate if the initialization is not performed.

HINT:

When the battery is replaced, it is not necessary to initialize the power window regulator motor.

NOTICE:

When the power window regulator motor is replaced, DTC B2313 is output. Clear the DTC after the initialization.

When performing initialization, do not perform any other procedures.

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used, due to detection of a value different from the operation learned value of the door glass movement speed. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

Open the power window by fully pushing down the power window switch.

Close the power window by fully pulling up the power window switch and holding it at the auto up position.

If the initialization is not completed properly, the LIN communication system may have a malfunction ().

Initialization procedures when replacing the power window regulator motor with a new one:

Connect the battery and turn the ignition switch ON.

Fully open the window by fully pushing the power window switch, and hold the switch for 1 second or more after the window is fully opened.

Fully close the power window by fully pulling the power window switch, and hold the switch for 1 second or more after the window is fully closed to reset the glass position.

Initialization procedures when removing/installing the power window regulator motor:

Connect the battery and turn the ignition switch ON.

Fully close the power window by fully pulling the power window switch, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).

Fully open the window by pushing down the power window switch, and hold the switch for 1 second or more after the window is fully opened.

Release the power window switch. Then fully push and hold the switch for 4 seconds or more.

Fully close the power window by fully pulling the power window switch, and hold the switch for 1 second or more after the window is fully closed to reset the glass position and complete the initialization.

Initialization procedures when the power window does not fully open:

Connect the battery and turn the ignition switch ON.

Fully close the power window by fully pulling the power window switch, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).

Fully open the window by pushing down the power window switch, and hold the switch for 1 second or more after the window is fully opened.

Release the power window switch. Then fully push and hold the switch 4 seconds or more.

Fully close the power window by fully pulling the power window switch, and hold the switch 1 second or more after the window is fully closed to reset the glass position and complete the initialization.

WINDOW / GLASS

Land Cruiser URJ200 URJ202 GRJ200 VDJ200

POWER WINDOW CONTROL SYSTEM for Models with Jam Protection Function on 4 Windows