Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - WINDOW / GLASS
POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) - INITIALIZATION
INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR (for Driver Side)) |
- CAUTION:
- When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up/down, jam protection and key-off do not operate if the initialization is not performed.
- HINT:
- When the battery is replaced, it is not necessary to initialize the power window regulator motor.
- NOTICE:
Initialization procedures when replacing the power window regulator motor with a new one:
Connect the battery and turn the ignition switch ON (at this time, the LED on the power window switch blinks to indicate that it is ready for initialization).
Fully open the window by fully pushing the power window switch, and hold the switch for 1 second or more after the window is fully opened.
Fully close the power window by fully pulling the power window switch, and hold the switch for 1 second or more after the window is fully closed to reset the glass position. The LED on the power window switch stops blinking and illuminated to indicate that the initialization is complete.
Initialization procedures when removing/installing the power window regulator motor:
Connect the battery and turn the ignition switch ON.
Fully close the power window by fully pulling the power window switch, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).
Fully open the window by pushing down the power window switch, and hold the switch for 1 second or more after the window is fully opened.
Release the power window switch. Then fully push and hold the switch for 4 seconds or more.
Fully close the power window by fully pulling the power window switch, and hold the switch for 1 second or more after the window is fully closed to reset the glass position and complete the initialization.
Initialization procedures when the power window does not fully open:
Connect the battery and turn the ignition switch ON.
Fully close the power window by fully pulling the power window switch, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).
Fully open the window by pushing down the power window switch, and hold the switch for 1 second or more after the window is fully opened.
Release the power window switch. Then fully push and hold the switch 4 seconds or more.
Fully close the power window by fully pulling the power window switch, and hold the switch 1 second or more after the window is fully closed to reset the glass position and complete the initialization.