Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - LIGHTING EXT
HEIGHT CONTROL SENSOR - INSPECTION
| 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
| *a | Component without harness connected (Rear Height Control Sensor Sub-assembly LH) | *b | Low (-) |
| *c | Normal | *d | High (+) |
- NOTICE:
- Do not drop the height control sensor. If it is dropped, replace it with a new one.
Connect 3 dry batteries of 1.5 V in series.
Connect the positive (+) end of the batteries to terminal 1 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 3 (SHG).
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection Condition Specified Condition 2 (SHRL) - 3 (SHG) High (+) Approx. 4.5 V Normal Approx. 2.25 V Low (-) Approx. 0.5 V
- NOTICE:
Do not apply a voltage of higher than 6 V.
Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.