Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - TIRE PRESSURE MONITORING


TIRE PRESSURE WARNING SYSTEM - INITIALIZATION

  • NOTICE:
Initialization can be confirmed through the tire pressure warning light.
The order in which the data is received is random.
If the signals from all the wheels are received, initialization is completed.
Initialization is completed when the Data List "ID Tire Inflation Pressure" display shows the correct pressures ().
Initialization is normally completed within a few minutes.
It may take up to a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 ().
If initialization has not been completed successfully, DTC C2177/77 is stored after the vehicle is driven at a speed of 37 km/h (23 mph) or more for 10 minutes or more.
During test mode (sensor check mode), the system will not change to initialization mode even if the tire pressure warning reset switch is pushed.
While the answer-back function for the ID switching function is operating, the system will not change to initialization mode even if the tire pressure warning reset switch is pressed.
Tire Pressure Warning System - Initialization. TIRE PRESSURE MONITORING. Land Cruiser URJ200  URJ202 GRJ200 VDJ200
Initialization can be terminated by connecting terminals 13 (TC) and 4 (CG) of the DLC3.
Text in Illustration
*aFront view of DLC3
BEFORE INITIALIZATION

Make sure that the tires are cold.

Set the air pressure of all tires to the specified value(s) ().

INITIALIZATION PROCEDURE

Turn the engine switch on (IG).

Press and hold the tire pressure warning reset switch for 3 seconds or more so that the tire pressure warning light blinks 3 times.

Tire Pressure Warning System - Initialization. TIRE PRESSURE MONITORING. Land Cruiser URJ200  URJ202 GRJ200 VDJ200

Text in Illustration
*Afor RHD*Bfor LHD
*1Tire Pressure Warning Light*2Tire Pressure Warning Reset Switch
*aTire Pressure Warning Light Output Pattern*b1 sec.
*cON*dOFF

Turn the engine switch off.

Connect the GTS to the DLC3.

Turn the engine switch on (IG) and turn the GTS on.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Check that initialization has been completed.

Confirm that the tire pressure data of all tires is displayed on the GTS screen.