Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - TIRE PRESSURE MONITORING
TIRE PRESSURE WARNING RECEIVER - INSTALLATION
| 1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER |
Connect the connector to the tire pressure warning ECU and receiver.
Attach the guide and clamp to temporarily install the tire pressure warning ECU and receiver.
Install the bolt.
- Torque:
- Bolt A:
- 13 N*m{ 127 kgf*cm, 9 ft.*lbf}
- Bolt B:
- 8.3 N*m{ 85 kgf*cm, 73 in.*lbf}
| *a | Bolt A |
| *b | Bolt B |
- NOTICE:
- The different marks on the heads of the bolts are shown in the illustration. Check whether the bolt being used is bolt A or bolt B, and then tighten the bolt using the appropriate torque.
| 2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH |
w/o Sliding Roof: ()
w/ Sliding Roof: ()
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 4. REGISTRATION OF TRANSMITTER ID |
()
| 5. INSPECT TIRE PRESSURE WARNING SYSTEM |
()
| 6. PERFORM INITIALIZATION |
()