Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - REAR SUSPENSION
REAR LOWER ARM - INSTALLATION
- HINT:
| 1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH |
Temporarily install the lower control arm and 2 washers with the 2 bolts and 2 nuts.
| 2. STABILIZE SUSPENSION |
Install the rear wheels.
- Torque:
- for aluminum wheel:
- 131 N*m{ 1336 kgf*cm, 97 ft.*lbf}
- for steel wheel:
- 209 N*m{ 2131 kgf*cm, 154 ft.*lbf}
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 3. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH |
Tighten the 2 nuts.
- Torque:
- 150 N*m{ 1530 kgf*cm, 111 ft.*lbf}
- NOTICE:
- Perform this procedure with all 4 wheels on the ground.
| 4. MEASURE VEHICLE HEIGHT (w/ KDSS) |
- NOTICE:
- HINT:
Set the tire pressure to the specified value(s) ().
Bounce the vehicle to stabilize the suspension.
Measure the distance from the ground to the top of the bumper and calculate the difference in the vehicle height between left and right. Perform this procedure for both the front and rear wheels.
- Height difference of left and right sides:
- 15 mm (0.591 in.) or less
- HINT:
- If not as specified, perform the vehicle tilt calibration.
| 5. CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS) |
- NOTICE:
- HINT:
Using a 5 mm hexagon socket wrench, tighten the lower and upper chamber shutter valves of the stabilizer control with accumulator housing.
- Torque:
- 14 N*m{ 143 kgf*cm, 10 ft.*lbf}
| 6. INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS) |
Install the valve protector with the 3 bolts.
- Torque:
- 18 N*m{ 184 kgf*cm, 13 ft.*lbf}
Attach the clamp, and connect the connector to the valve protector.