Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - REAR SUSPENSION
REAR LATERAL CONTROL ROD - REMOVAL
| 1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS) |
Detach the clamp, and disconnect the connector from the protector.
Remove the 3 bolts and protector.
| 2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS) |
Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.
- NOTICE:
When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
Do not remove the shutter valves.
| 3. SUPPORT REAR AXLE HOUSING ASSEMBLY |
Support the rear axle housing with a jack using a wooden block to avoid damage.
| 4. REMOVE REAR LATERAL CONTROL ROD ASSEMBLY |
Remove the 2 bolts, nut, washer and lateral control rod.