Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SUSPENSION CONTROL
HEIGHT CONTROL SENSOR (for Rear Side) - INSTALLATION
| 1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
Install the sensor with the 2 bolts and nut.
- Torque:
- for bolt:
- 13 N*m{ 127 kgf*cm, 9 ft.*lbf}
- for nut:
- 5.6 N*m{ 57 kgf*cm, 50 in.*lbf}
Connect the connector and 2 clamps.
| 2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH |
Install the sensor with the 2 bolts and nut.
- Torque:
- for bolt:
- 13 N*m{ 127 kgf*cm, 9 ft.*lbf}
- for nut:
- 5.6 N*m{ 57 kgf*cm, 50 in.*lbf}
Connect the connector and 2 clamps.
| 3. INSTALL REAR WHEEL |
- Torque:
- for Aluminum Wheel:
- 131 N*m{ 1336 kgf*cm, 97 ft.*lbf}
- for Steel Wheel:
- 209 N*m{ 2131 kgf*cm, 154 ft.*lbf}
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 5. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION |
Perform the vehicle height offset calibration ().
| 6. ADJUST REAR HEIGHT SENSOR LINK SUB-ASSEMBLY |
- NOTICE:
Make adjustments from the link that deviates the most from the specified vehicle height value.
When the front and rear are at the same level, make adjustments from the front first.
If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.
Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.
- HINT:
- When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).
Tighten the nut of the height control sensor link.
- Torque:
- 5.6 N*m{ 57 kgf*cm, 50 in.*lbf}
| 7. PERFORM ZERO POINT CALIBRATION OF G SENSOR |
Perform the zero point calibration of G sensor ().
| 8. ADJUST HEADLIGHT ASSEMBLY |
for Standard:
Adjust the headlight ().
for HID Headlight:
Adjust the headlight ().