INSPECT ACCELERATION SENSOR

Connect 3 dry batteries of 1.5 V in series.

Connect the positive (+) end of the battery to terminal 3 (SGB) of the acceleration sensor and the negative (-) end of the battery to terminal 2 (SGG). Then measure the voltage between terminal 1 (SGFR*1, SGFL*2) and terminal 2 (SGG).

• HINT:

• *1: for RH

• *2: for LH

Measure the voltage according to the value(s) in the table below.

• Standard Voltage:

• for RH

  Tester Connection	Condition	Specified Condition
  1 (SGFR) - 2 (SGG)	Sensor is stationary	Approx. 2.0 to 2.5 V
  	Sensor is tilted	Change between approx. 0.9 to 2.3 V

• for LH

  Tester Connection	Condition	Specified Condition
  1 (SGFL) - 2 (SGG)	Sensor is stationary	Approx. 2.0 to 2.5 V
  	Sensor is tilted	Change between approx. 0.9 to 2.3 V

• NOTICE:

• Do not apply a voltage of higher than 6 V.

• HINT:

• The voltage may differ according to the amount that the sensor is tilted.