VANE PUMP (for 1UR-FE) - REMOVAL

1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().

3. REMOVE FRONT WHEEL RH

4. REMOVE FRONT FENDER APRON TRIM PACKING A

Vane Pump (For 1Ur-Fe) - Removal. POWER ASSIST SYSTEMS. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Remove the 3 bolts and 2 screws.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.

5. REMOVE V-BANK COVER SUB-ASSEMBLY

Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

Text in Illustration
*1	Grommet
*2	Pin
*3	Hook
*4	Bracket

6. REMOVE AIR CLEANER AND HOSE

Disconnect the No. 2 PCV hose and No. 1 air hose.

Disconnect the mass air flow meter connector and detach the clamp.

Remove the 3 bolts and loosen the hose clamp, and then remove the air cleaner and hose.

7. REMOVE FAN AND GENERATOR V BELT

While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar with a diameter of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.