Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - STEERING COLUMN


POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM - HOW TO PROCEED WITH TROUBLESHOOTING

  • HINT:
Use the following procedures to troubleshoot the power tilt and telescopic steering column system.
*: Use the intelligent tester.

1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
  • Standard voltage:
  • 11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT
3.CHECK CAN COMMUNICATION SYSTEM*

Use the intelligent tester to check if the CAN communication system is functioning normally.

Result
ResultProceed to
CAN DTC is not outputA
for LHD:
CAN DTC is output		B
for RHD:
CAN DTC is output		C
B.
Go to CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) ()
C.
Go to CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) ()
A
4.CHECK FOR DTC*

Check for DTCs ().

Clear the DTCs ().

Recheck for DTCs ().

Result
ResultProceed to
DTC is not outputA
DTC is outputB
B.
Go to POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) ()
A
5.PROBLEM SYMPTOMS TABLE
Result
ResultProceed to
Fault is not listed in problem symptoms tableA
Fault is listed in problem symptoms tableB
B.
Go to step 7
A
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

Terminals of ECU ()

Data List/Active Test ()

NEXT
7.REPAIR
NEXT
8.CONFIRMATION TEST
NEXT
END
STEERING COLUMN
Land Cruiser URJ200 URJ202 GRJ200 VDJ200
POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM