Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - POWER ASSIST SYSTEMS


POWER STEERING SYSTEM (for 1VD-FTV with DPF) - DATA LIST / ACTIVE TEST

DATA LIST
  • HINT:
  • Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
  • NOTICE:
  • In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Turn the engine switch off.

Connect the GTS to the DLC3.

Turn the engine switch on (IG).

Turn the GTS on.

Enter the following menus: Chassis / PPS / Data List.

According to the display on the GTS, read the Data List.

PPS
Tester DisplayMeasurement Item/RangeNormal ConditionDiagnostic Note
Steering Angle VelocitySteering angle speed/
Min.: -32768 deg/s
Max.: 32767 deg/s
Value changes in proportion to steering effortThe engine is running and the steering wheel is being turned.
Meter Vehicle VelocityVehicle speed from meter/
Min.: 0.00 km/h (0.00 mph)
Max.: 300.00 km/h (186.41 mph)
0 km/h (0 mph)The vehicle is stopped.
No large fluctuationThe vehicle is driven at a constant speed.
Engine RevolutionEngine speed/
Min.: 0 rpm
Max.: 12800 rpm
No large fluctuationThe engine is running at a constant speed.
Steering AngleSteering angle/
Min.: -2048.0 deg
Max.: 2047.0 deg
Left turn: Increases
Right turn: Decreases
The engine is running and the steering wheel is being turned.
Solenoid CurrentSolenoid Current/
Min.: 0 mA
Max.: 1000 mA
200 to 950 mAThe engine is running and the steering wheel is being turned.
IG Power SupplyECU power source voltage/
Min.: 0.0 V
Max.: 25.5 V
11 to 14 V The engine switch is on (IG)
The Number of DTCsNumber of DTCs/
Min.: 0
Max.: 255
0-