Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE COOLING
WATER PUMP - ON-VEHICLE INSPECTION
| 1. INSPECT FOR COOLANT LEAK |
- HINT:
The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces. In this case, check the area around the engine water pump assembly.
Before performing this inspection, check that there are no engine coolant leaks from any parts other than the engine water pump assembly. If there are leaks, inspect those areas first.
Perform this inspection when the engine is cold.
Visually check the engine water pump assembly.
Check that engine coolant is not dripping from the engine water pump assembly.
- HINT:
If engine coolant is dripping, replace the engine water pump assembly.
If engine coolant is not dripping, perform the following check.
Inspect the area around the water pump.
- HINT:
- Check for deposits around the drain hole of the water pump.
Press the thin paper towel against the coolant (solid matter) adhering to the drain hole or the edge of the drain hole, and check the condition of the thin paper towel.
| *1 | Water Pump Pulley |
| *2 | Drain Hole |
- HINT:
If the thin paper towel is wet, replace the water pump assembly.
If the thin paper towel is dry, thoroughly clean the area around the water pump.
| 2. INSPECT ENGINE WATER PUMP ASSEMBLY |
Remove the fan and generator V belt ().
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump.
Install the fan and generator V belt ().