SNORKEL AIR CLEANER - REMOVAL

1. REMOVE AIR PRE-CLEANER ASSEMBLY

Remove the bolt, air pre-cleaner and No. 2 inlet air cleaner bracket.

2. REMOVE COOL AIR INTAKE DUCT

Remove the 2 bolts and cool air intake duct.

3. REMOVE COOL AIR INTAKE PIPE RETAINER

Remove the 2 bolts and cool air intake pipe retainer.

4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Remove the 3 bolts and 2 screws.

Loosen the clip and remove the front fender splash shield RH.

5. REMOVE FRONT FENDER LINER RH

Remove the screw and disconnect the liner from the front bumper cover.

Using a T30 "TORX" socket, remove the 3 screws.

Remove the 5 clips.

It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.

6. REMOVE NO. 1 INLET AIR CLEANER

Remove the 2 bolts.

Detach the claw shown in the illustration, and then remove the No. 1 inlet air cleaner.

7. REMOVE AIR CLEANER ASSEMBLY

Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.

Using a clip remover, detach the wire harness clamp from the air cleaner case.

Remove the 3 bolts and air cleaner case.

8. REMOVE NO. 2 INLET AIR CLEANER

Remove the 2 bolts and inlet air cleaner.

9. REMOVE INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY

Remove the 2 bolts and inlet air cleaner seal bracket.