Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE CONTROL
SFI SYSTEM - HOW TO PROCEED WITH TROUBLESHOOTING
- HINT:
- *: Use the GTS.
1.VEHICLE BROUGHT TO WORKSHOP |
|
2.CUSTOMER PROBLEM ANALYSIS |
|
3.CONNECT GTS TO DLC3* |
- HINT:
- If the display indicates a communication fault in the GTS, inspect the DLC3.
|
4.CHECK DTC AND FREEZE FRAME DATA* |
Check DTC ().
Check freeze frame data ().
- HINT:
- Record or print DTCs and freeze frame data, if necessary.
|
5.CLEAR DTC AND FREEZE FRAME DATA* |
Clear the DTC ().
|
6.CONDUCT VISUAL INSPECTION |
|
7.SET CHECK MODE DIAGNOSIS* |
Switch the ECM from normal mode to check mode ().
|
8.CONFIRM PROBLEM SYMPTOMS |
Refer to "Problem Symptoms Table" ().
- HINT:
- If the engine does not start, first perform the "Check DTC" procedures and "Conduct Basic Inspection" procedures below.
Result | Proceed to |
Malfunction does not occur | A |
Malfunction occurs | B |
|
| ||||
|
9.SIMULATE SYMPTOMS |
|
10.CHECK DTC* |
Check DTC ().
Result | Proceed to |
Trouble code output | A |
No code output | B |
|
| ||||
|
11.REFER TO DTC CHART |
Refer to "Diagnostic Trouble Code Chart" ().
| ||||
|
---|
12.CONDUCT BASIC INSPECTION |
Refer to "Basic Inspection" ().
Result | Proceed to |
Malfunctioning parts not confirmed | A |
Malfunctioning parts confirmed | B |
|
| ||||
|
13.REFER TO PROBLEM SYMPTOMS TABLE |
Refer to "Problem Symptoms Table" ().
Result | Proceed to |
Malfunctioning circuit confirmed | A |
Malfunctioning parts confirmed | B |
|
| ||||
|
14.CHECK ECM POWER SOURCE CIRCUIT |
Refer to "ECM Power Source Circuit" ().
|
15.CONDUCT CIRCUIT INSPECTION |
Result | Proceed to |
Malfunction not confirmed | A |
Malfunction confirmed | B |
|
| ||||
|
16.CHECK FOR INTERMITTENT PROBLEMS |
Refer to "Check for Intermittent Problems" ().
| ||||
|
---|
17.CONDUCT PARTS INSPECTION |
|
18.IDENTIFY PROBLEM |
|
19.ADJUST AND/OR REPAIR |
|
20.CONDUCT CONFIRMATION TEST |
| ||||
|
---|