Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE CONTROL

SFI SYSTEM - CHECK MODE PROCEDURE

• HINT:

• Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that may not be detected in normal mode.

• NOTICE:

• All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the engine switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.

Check that the following conditions are met:

Battery positive voltage 11 V or higher.

Throttle valve fully closed.

Shift lever in P or N.

A/C switch off.

Turn the engine switch off.

Connect the GTS to the DLC3.

Turn the engine switch on (IG).

Turn the GTS on.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.

Switch the ECM from normal mode to check mode.

Make sure the MIL flashes as shown in the illustration.

Start the engine.

Make sure the MIL turns off.

Simulate the conditions of the malfunction described by the customer.

Check DTCs and freeze frame data using the GTS.