INSPECT PURGE VSV

Measure the resistance according to the value(s) in the table below.

• Standard Resistance:

• Tester Connection	Condition	Specified Condition
  1 - 2	20°C (68°F)	23 to 26 Ω
  1 - Body ground	Always	10 MΩ or higher
  2 - Body ground	Always	10 MΩ or higher

• HINT:

• When measuring the coil resistance, make sure that the surface temperature of the purge VSV is 20°C (68°F).

If the result is not as specified, replace the purge VSV.

Check the operation of the purge VSV.

Check that air does not flow from port E to port F.

Text in Illustration

*1	Port E
*2	Port F
*a	Does not flow
	Air pressure

Apply battery voltage to the connector and check the VSV operation.

• OK:

• Measurement Condition	Specified Condition
  Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2	Air flows from port E to port F

Text in Illustration

*1	Port E
*2	Port F
	Air pressure

If the result is not as specified, replace the purge VSV.