INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

ADD ENGINE OIL

INSPECT FOR ENGINE OIL LEAK

CHECK ENGINE OIL LEVEL

INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Remove the adhesive from the threads of the oil pressure sender gauge and the bolt hole of the oil filter bracket.

Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

• Adhesive:
• Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

• NOTICE:

• Do not apply adhesive to the oil inlet port of the sensor.

Install the oil pressure sender gauge.

• Torque:
• 15 N*m{ 153 kgf*cm, 11 ft.*lbf}

• NOTICE:

• Do not start the engine within 1 hour after installation.

Connect the oil pressure sender gauge connector.

Add fresh oil.

• Standard Engine Oil:

• Item	Oil Grade	Oil Viscosity (SAE)
  w/ DPF	ACEA C2 (Using engine oil other than ACEA C2 may damage catalytic converter)	- 0W-30 - 5W-30 (0W-30 is best choice for fuel economy and good starting in cold weather)
  w/o DPF	G-DLD-1, API CF-4, API CF or ACEA B1 (You may also use API CE or CD)	- 5W-30 - 10W-30 - 15W-40 - 20W-50 (5W-30 is best choice for fuel economy and good starting in cold weather).

• Standard Capacity:

• Item	Specified Condition
  Drain and refill with oil filter change	9.2 liters (9.7 US qts, 8.1 Imp. qts)
  Drain and refill without oil filter change	8.2 liters (8.7 US qts, 7.2 Imp. qts)
  Dry fill	9.9 liters (10.5 US qts, 8.7 Imp. qts)

Install the oil filler cap.

Warm up the engine and check for an engine oil leak.

Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

If low, check for leakage and add oil up to the full level mark.

• NOTICE:

• Do not fill engine oil above the full level mark.

• HINT:

• A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

• When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.

Install the No. 1 engine under cover with the 10 bolts.

• Torque:
• 29 N*m{ 296 kgf*cm, 21 ft.*lbf}

Install the front fender splash shield RH with the clip, and then install the 3 bolts and 2 screws.

Install the front fender splash shield LH with the clip, and then install the 3 bolts and screw.