REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

REMOVE NO. 2 ENGINE UNDER COVER

DRAIN ENGINE OIL

DISCONNECT OIL COOLER TUBE

REMOVE ENGINE OIL LEVEL SENSOR

Remove the 3 bolts and screw.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.

Push in the clip to install the front fender splash shield sub-assembly RH.

Install the 3 bolts and 2 screws.

Remove the 10 bolts and No. 1 engine under cover sub-assembly.

Remove the 2 bolts and No. 2 engine under cover.

Remove the oil filler cap.

Remove the 2 bolts and No. 2 engine under cover seal.

Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

Install a new gasket and the oil pan drain plug.

• Torque:
• 40 N*m{ 408 kgf*cm, 30 ft.*lbf}

Install the No. 2 engine under cover seal with the 2 bolts.

• Torque:
• 10 N*m{ 102 kgf*cm, 7 ft.*lbf}

Remove the 2 bolts and disconnect the oil cooler tube.

Disconnect the oil level sensor connector.

Remove the 4 bolts and oil level sensor.

Cut away part of the gasket and remove the gasket from the engine oil level sensor.

• HINT:

• Remove the only the outer part of the gasket.