Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE CONTROL
KNOCK SENSOR - INSTALLATION
| 1. INSTALL KNOCK SENSOR |
Install the 4 knock sensors with the 4 bolts so that the knock sensors are angled as shown in the illustration.
- Torque:
- 20 N*m{ 204 kgf*cm, 15 ft.*lbf}
| *A | for Bank 2 Sensor 1 |
| *B | for Bank 1 Sensor 1 |
| *C | for Bank 2 Sensor 2 |
| *D | for Bank 1 Sensor 2 |
 | Front |
 | Upper Side |
 | Rear |
Connect the 4 knock sensor connectors.
| 2. INSTALL NO. 1 ENGINE COVER |
| 3. INSTALL NO. 2 ENGINE COVER |
| 4. INSTALL SEPARATOR CASE |
Install the separator case with the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
| 5. INSTALL NO. 3 ENGINE COVER |
Install the No. 3 engine cover.
 | Engine Front |
- HINT:
- Position the No. 3 engine cover so that the arrow mark faces the front of the engine and install it.
| 6. INSTALL NO. 4 ENGINE COVER |
Install the No. 4 engine cover.
| Engine Front |
- HINT:
- Position the No. 4 engine cover so that the arrow mark faces the front of the engine and install it.
| 7. INSTALL NO. 1 EGR PIPE BRACKET |
Install the No. 1 EGR pipe bracket with the 3 bolts.
- Torque:
- 21 N*m{ 214 kgf*cm, 15 ft.*lbf}
| 8. INSTALL NO. 1 WATER OUTLET PIPE |
Install the No. 1 water outlet pipe with the 2 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
| 9. CONNECT NO. 11 WATER BY-PASS HOSE |
Connect the No. 11 water by-pass hose.
| *1 | Paint Mark |
| *a | Upper Side |
- HINT:
- The direction of the hose clamp is indicated in the illustration.
| 10. CONNECT NO. 8 WATER BY-PASS HOSE |
Install the No. 8 water by-pass hose.
| *1 | Paint Mark |
| *a | Upper Side |
| *b | Front |
- HINT:
When connecting the hose, make sure the paint marks and clips are as shown in the illustration.
The direction of each hose clamp is indicated in the illustration.
| 11. INSTALL NO. 2 WATER BY-PASS PIPE |
Install the No. 2 water by-pass pipe with the 2 bolts and connect the hose.
- Torque:
- 10 N*m{ 102 kgf*cm, 7 ft.*lbf}
| *1 | Paint Mark |
| *a | Upper Side |
- HINT:
When connecting the hose, make sure the paint marks and clips are as shown in the illustration.
The direction of each hose clamp is indicated in the illustration.
| 12. INSTALL INTAKE MANIFOLD |
()