Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1UR-FE ENGINE CONTROL
IGNITION COIL AND SPARK PLUG - REMOVAL
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| *1 | Grommet |
| *2 | Pin |
| *3 | Hook |
| *4 | Bracket |
| 2. REMOVE AIR CLEANER AND HOSE |
Disconnect the No. 2 PCV hose and No. 1 air hose.
Disconnect the mass air flow meter connector and detach the clamp.
Remove the 3 bolts and loosen the hose clamp, and then remove the air cleaner and hose.
| 3. REMOVE IGNITION COIL ASSEMBLY |
for Bank 1:
Detach the 4 clamps and disconnect the engine wire.
Disconnect the 4 ignition coil connectors.
Remove the 4 bolts and 4 ignition coils.
for Bank 2:
Remove the 2 bolts and disconnect the water by-pass pipe.
Detach the 3 clamps and disconnect the engine wire.
Disconnect the 4 ignition coil connectors.
Remove the 4 bolts and 4 ignition coils.
| 4. REMOVE SPARK PLUG |
Using a 16 mm plug wrench, remove the 8 spark plugs.