Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV STARTING

GLOW PLUG - INSTALLATION

  • NOTICE:
When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
w/DPF
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines ().
1. INSTALL GLOW PLUG ASSEMBLY

Clean the glow plug and glow plug hole.

Glow Plug - Installation. 1VD-FTV STARTING. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

Apply adhesive to 3 or more thread roots in the area shown in the illustration.

  • Adhesive:
  • Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration
*a12 Thread Roots

Using a 10 mm deep socket wrench, install the 8 glow plugs.

  • Torque:
  • 12 N*m{ 125 kgf*cm, 9 ft.*lbf}
2. INSTALL NO. 1 GLOW PLUG CONNECTOR

Install the 2 glow plug connectors by uniformly tightening the 8 nuts.

  • Torque:
  • 2.2 N*m{ 22 kgf*cm, 19 in.*lbf}

Install the 8 screw grommets.

Connect the 2 wire harnesses with the 2 nuts and 2 screw grommets.

  • Torque:
  • 4.0 N*m{ 41 kgf*cm, 35 in.*lbf}
3. INSTALL INJECTION PIPES

()


4. INSTALL INTERCOOLER ASSEMBLY (w/ Intercooler)

()


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  • NOTICE:
  • When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
1VD-FTV STARTING
Land Cruiser URJ200 URJ202 GRJ200 VDJ200
GLOW PLUG