Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1GR-FE FUEL
FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) - REMOVAL
| 1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work ().
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 3. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side) |
()
| 4. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side) |
()
| 5. REMOVE REAR NO. 2 SEAT ASSEMBLY |
for Face to Face Seat Type ()
except Face to Face Seat Type ()
| 6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
w/ Sliding Roof ()
w/o Sliding Roof ()
| 7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH |
w/ Sliding Roof ()
w/o Sliding Roof ()
| 8. REMOVE REAR FLOOR MAT ASSEMBLY |
w/ Rear Air Conditioning System:
Detach the 5 clips and fold back the floor mat toward the front of the vehicle.
- HINT:
- Fold back the floor mat so that the rear No. 7 air duct can be removed.
w/o Rear Air Conditioning System:
Detach the 5 clips and fold back the floor mat toward the front of the vehicle.
- HINT:
- Fold back the floor mat so that the service hole cover can be removed.
| 9. REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System) |
Detach the 4 clips and remove the air duct.
| 10. REMOVE REAR FLOOR SERVICE HOLE COVER |
| 11. REMOVE FUEL SENDER GAUGE ASSEMBLY |
Disconnect the sender gauge connector.
Remove the 5 screws and sender gauge.
- NOTICE:
- Be careful not to bend the arm of the fuel sender gauge.
Remove the gasket from the sender gauge.