Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - 1VD-FTV ENGINE MECHANICAL
FRONT CRANKSHAFT OIL SEAL - INSTALLATION
| 1. INSTALL FRONT CRANKSHAFT OIL SEAL |
Apply engine oil to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal as shown in the illustration.
- SST
- 09316-12010
09950-70010(09951-07100)
09950-60020(09951-00890)
- Standard depth A:
- 0.6 to 1.4 mm (0.0236 to 0.0551 in.)
- NOTICE:
- Make sure that the lip of the oil seal is properly installed.
| 2. INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY |
- NOTICE:
- This procedure is intended for removal/installation of the crankshaft pulley only. Do not use this procedure for removal/installation of the flywheel or the drive plate and ring gear.
Align the crankshaft pulley and the crankshaft knock pin, and temporarily install the crankshaft pulley with the 3 bolts.
| *1 | Service Hole |
| *2 | Protrusion |
Install the 2 bolts to the bolt holes of the crankshaft rear side.
Using a bar, turn the crankshaft until the crankshaft pulley service hole is a little to the right of bottom dead center.
Install a 14 mm x 1.5 pitch service bolt with a length of 70 mm or more to the crankshaft pulley service hole, and hold the crankshaft using the timing chain cover protrusion.
Uniformly tighten the 3 bolts in 2 passes in the order shown in the illustration.
- Torque:
- 115 N*m{ 1168 kgf*cm, 84 ft.*lbf}
Remove the service bolt.
| 3. INSTALL RADIATOR ASSEMBLY |
()